|
Step 1: Preparation
Clean Glass: Using Alcohol or Dish Washing Detergent.
Then dry and set aside on a clean piece of paper or
cardboard.
Clean & Prep Kiln Shelf: Apply Kiln Wash (Shelf Primer)
or cut squares of shelf paper.
Step 2: Assemble Glass
Stack the glass: Black square base, Dichroic Glass
Circle,
centered and the clear square of glass on top. Hold them
together with Fuser's Glue.
Cut out the large square of the Celtic Decal. Soak
it 10 to
20 seconds in clean water and slide it on top of the
clear glass, centered over the Dichroic glass circle
Let
sit for at least 10 minutes before moving.
Notes:
1. When using a Black Decal over Dichroic glass,
it is best to do a full fuse first so you know if the color
of the final glass is going to be too dark for the black
decal on the surface of the glass.
2. To achieve the deepest black
and crisp line detail of the
decal. Fire the glass pendant to a full fused
first and then apply the decal and fire a second time to a tack fused
at approximately 1325 degrees for a least 1 minute.
Step 3: Place Project into Kiln
Using Fingers around outer edges of the fusible glass
project or better yet wear latex gloves, pick up and
place the project on the kiln shelf paper/shelf.
Step 4: Full Fuse |
