|
Step 1: Preparation
Clean Glass: Using Alcohol or Dish Washing Detergent.
Then dry and set aside on a clean piece of paper or
cardboard.
Clean & Prep Kiln Shelf: Apply Kiln Wash (Shelf Primer)
or cut squares of shelf paper.
Step 2: Assemble Glass
Stack the 2 black glass squares
and the white glass on top centered. Hold them
together with Fuser's Glue.
Cut out a 3/4 to 1/2 inch square of the Zebra Decal. Soak
it 10 to
20 seconds in clean water and slide it on top of the
white glass, centered.
Let
sit for at least 10 minutes before moving.
Step 3: Place Project into Kiln
Using Fingers around outer edges of the fusible glass
project or better yet wear latex gloves, pick up and
place the project on the kiln shelf paper/shelf.
Step 4: Full Fuse |
