|
Step 1: Preparation
Clean Glass: Using Alcohol or Dish Washing Detergent.
Then dry and set aside on a clean piece of paper or
cardboard.
Clean & Prep Kiln Shelf: Apply Kiln Wash (Shelf Primer)
or cut squares of shelf paper.
Step 2: Assemble Glass
Cut 5, 1/2 inch squares
of
Premium Green-Pink Dicro Slide tm. Then cut 3
smaller squares for the green glass. Soak them
20 seconds in water and position them onto the top black
layer.
Using just
a tiny spec of
Fuser's Glue
position the 3 green glass squares.
Let
sit for at least 10 minutes before moving.
Step 3: Place Project into Kiln
Using Fingers around outer edges of the fusible glass
project or better yet wear latex gloves, pick up and
place the project on the kiln shelf paper/shelf.
Step 4: Full Fuse |
