|
Step 2: Assemble Knob for Fusing.
If you want a uniform design for repeating when creating
several of the same item,
we suggest you cut a small pattern out of plain paper to
use when cutting out Dicro
Slide ™.
Place the glass shape on the back side of the Dicro Slide ™ and trace the shape of the circle.
Follow the instructions for soaking and applying the dicro slide. Dicro Slide goes on top of the Black or White piece.
After the Dicro Slide is fairly dry and not moving, set the clear
shape on top.
Note: if you place a small drop of moisture on the bottom of your clear piece before setting on the dicro slide base and let them sit, we have found they will dry together and thus eliminate the need for any glue to adhere them together. But, make sure the two pieces are lined up evenly.
After about 30 minutes to an hour, or wait until the next day, take your
X-acto™ Knife and trim off any excess Dicro Slide ™ or decal by using a down ward angle so as not to lift off any product. This produces a nice clean edge with a consistent color and gives a more refined appearance.
TIP: Dicro
Slide ™
and
Scrap
Dichroic
is less sensitive in application and can be fired the
same day.
|
