|
Step 1 - Preparation
Clean Glass: Using Alcohol or Dish Washing Detergent.
Then dry and set aside on a clean piece of paper or
cardboard.
Clean & Prep Kiln Shelf: Apply Kiln Wash (Shelf Primer)
or cut squares of shelf paper.
Break up small pieces of Dichroic glass.
Step 2 – Assemble Glass
Using just
a tiny spec of
Adhesive
Glastac
on the
matching edges of the Yin Yang and push together.
Position the Dichroic
on each side of the Yin Yang as desired using a tiny
spec of Glastac to hold into position. Use Glastac
on a surface of a few of the Dichroic scraps and lay the
clear cap glass on top, aligned and centered over the
base. Let sit and dry to hold all pieces into
position.
Note:
Elmer's™ Glue
is not recommended as it will not burn off cleanly in
the center area and may leave dark spots under the clear
cap.
Step 3 - Place Project into Kiln
Using Fingers around outer edges of the fusible glass
project or better yet wear latex gloves, pick up and
place the project on the kiln shelf paper/shelf.
Step 4 – Full Fuse |
»»
Login Status
